38
the machine automatically loads the heater
with water and begins heating operations.
When the desired temperature is reached
the display will show the following messa-
ge:
NOTE
: the starting time is about 3 minutes.
NOTE
: the appliance is endowed with a secu-
rity system that will stop the machine
after about 1.5 minutes of constant
functioning of the pump (to avoid pump
overheating). In this case, switch off the
main switch of the machine and then
turn it on again.
The machine is now ready to be used.
Switch on the grinder to carry out the grin-
ding adjustment procedures.
NOTE
: the procedure is possible also with the
appliance on.
• Put the key into its lock.
• Turn the control panel hatchdoor key coun-
ter- clockwise.
• Open the hatchdoor, to gain access to the
coffee grinder adjusting screw. Following
the direction of the arrows and using a 3 mm
(0,12 in) allen wrench, grinding of the coffee
beans can be adjusted to COARSER
(counter-clockwise) or FINER (clockwise).
• Lock the hatchdoor.
WARNING
NOTE
: the procedure is possible also with the
appliance on.
• Put the key into its lock.
• Turn the control panel hatchdoor key coun-
ter-clockwise.
• Open the hatchdoor, to gain access to the
adjusting screw.
To adjust the delivery of air from the milkfoamer
and, consequently, the amount of foam delive-
red, turn the adjusting screw as follows:
• Loosen the safety ring nut counter-clockwi-
se.
• Turn the adjusting screw as shown on the
hatchdoor label to increase/decrease air
delivery from the foam maker.
• Once the desired airflow has been reached,
tighten the safety ring nut by turning it clock-
wise.
NOTE
: in case the following procedure should-
n't take effect, see the chapter on
"Problems and Solutions".
After the preliminary operations:
1
Press the main switch so that the LCD dis-
play turns on showing the message:
Fig. 19
FINO
FINE
GOARSE
GROSSO
Fig. 18
OPEN
CLOSED
5.
ADJUSTMENTS TO BE MADE
BY A QUALIFIED TECHNICIAN ONLY
5.1
GRINDING
ADJUSTMENT
5.2
MILK FOAMER
ADJUSTMENT
ENGLISH
