Nuova Simonelli Oscar II, Руководство по обслуживанию

Страница: 18 / 84

2.1.5 PrOceDure OF FirST
inSTallaTiOn
Before carrying out the installation carefully read
the safety instructions at the beginning of this
manual and particularly about how to put THE
MACHINE INTO ZERO ENERGY STATUS.
1
Once the machine has been removed from
the packaging, position it on a horizontal
surface and proceed with the installation as
illustrated in the following paragraphs.
Arrange the accessories as follows:
2
Insert the ring in its seat inside the filter
holder.
3 Insert one of the two filters.
4 Caution: danger of pollution.
DanGer OF POlluTiOn
Fig. 16
Tank Model:
5 Open the hatch and take out the reservoir.
Especially the first time, wash the reservoir
with soap and water. Fill the reservoir with
water and make certain that the outside of
the reservoir is dry.
6 Return the reservoir to its housing and close
the hatch.
7
Make certain that the water drain tank has
been inserted.
nOTe
If the machine does not have enough water in the
tank or the pump stays on for more than 90 sec-
onds, the machine will stop and all the buttons
flash. Getting on and off the machine: operation
of the filling boiler will run until the appropriate
level.
2.1.3 TecHnical SPeciFicaTiOnS
The machine is available in the following ver-
sions:
• single-phase 120 V 60 Hz (tank and waterline)
• single-phase 230 V 50 Hz (tank and waterline)
• single-phase 230 V 60 Hz (waterline)
The relative power absorbed is indicated on the
machine plate.
2.1.4 cOnnecTiOn TO THe POWer line
Before utilising the machine, the operator must
have read and fully understood the safety instruc-
tions in this manual.
Connect the machine to the power socket.
The machine carries out the following checks.
Fig. 15
OK
Fig. 14
Ed. 02 of 09/2016
2.4
Service Manual
AUTORYZOWANY DYSTRYBUTOR
w w w . s i m o n e l l i g r o u p . p l