Numatic TTV 678, Инструкция пользователя

Страница: 7 / 32

7
Only use brushes provided with the appliance or those specified in the instruction manual.
The use of other brushes may impair safety.
A full range of brushes and accessories are available for this product.
Only use brushes or pads which are suitable for the correct operation of the machine for the specific task
being performed.
It is essential that this equipment is correctly assembled and operated in accordance with current safety regulations.
When using the equipment always ensure that all necessary precautions are taken to guarantee the safety of the operator
and any other persons who may be affected.
Wear non-slip footwear when Scrubbing.
Use a respiratory mask in dusty environments.
The machine, while charging, must be positioned so that the mains plug is easily accessible.
Remove the key from the ignition when cleaning and carrying out routine maintenance.
When replacing major components the ignition key and battery fuses MUST be removed.
In order to prevent unauthorized use of the machine, the power source shall be switched off or locked, for example by
removing the ignition key.
When detergents or other liquids are used, read the manufacturer’s instructions.
Operators shall be adequately instructed as to the correct use of the machine.
If this product does not have a factory installed Numatic battery charger, then it is the responsibility of the owner and user
of the product to ensure that the charging system and battery combination are compatible, fit for purpose and safe to use.
WARNING
1. Always wear protective clothing e.g. face visor, gloves and overalls when working with batteries.
2. Whenever possible always use a properly designated and well-ventilated area for charging.
Do not smoke or bring naked flames into the charging area.
3. Remove any metallic items from hands, wrists and neck i.e. rings, chains etc. before working on a battery.
4. Never rest tools or metallic objects on top of the battery.
5. When charging is complete disconnect from the mains supply.
6. The machine must be disconnected from the supply when removing the battery.
7. To remove the batteries:- Disconnect machine from the mains supply (if charging), raise waste water tank and ensure
batteries are isolated by removing fuses. Disconnect hoses from separator and tanks, undo battery terminals and
remove batteries.
8. Only use genuine Numatic replacement batteries.
9. Do not allow the batteries to become fully discharged, it may not be possible to recharge them.
10. Do not allow one battery to be discharged separately to the other.
11. Do not mix batteries from different machines.
12. The batteries fitted to this product are Valve Regulated Lead Acid (VRLA) gel electrolyte type.
The fitting of any other type of battery may cause a safety hazard.
13. The batteries must be removed from the machine before it is scrapped.
14. Dispose of the batteries safely in accordance with local government regulations.
Precautions when working with batteries
1. Always recharge the batteries after use. This can be done at any time – it is not necessary to wait until they are fully
discharged; they do not develop a “memory”.
2. Leaving the charger to operate for a minimum of 4 hours after the green light has come on, at least weekly,
will prolong battery life.
3. Do not store the machine with the batteries discharged.
Battery care
Daily
Keep the machine clean.
Ensure brushes/ pads/ squeegee/ filters are in good condition.
Check for any worn or damaged parts and replace immediately.
Drain and rinse dirty water tank after every use.
Store machine with brush deck secured in tilted position.
Weekly – as daily and –
Check brush or pad and skirt and rinse.
Check floor tool blades for wear and wipe clean.
Clean separator assembly including filter and check condition of seal.
Flush out system with clean water and clean filters.
Do not steam clean or pressure wash.
Batteries
Always recharge the batteries after use.
Charge for a minimum of 4 hours after the green light has come on, this will prolong battery life.
TwinT
ec
Maintenance