NuAire ecosmart CONNECT XBOXER XBC, Установка, Подробности Управления, Эксплуатация и Обслуживание

Страница: 25 / 64

25 nuaire.co.uk
XBOXER XBC ECOSMART (CO) MODELS
9.0 FC BUS DEVICES
30. 11. 15. Leaflet Number 671710
9.1 FAC CONTROLLER
Figure 17:
A FAC controller is used to control the unit. The controller can connect to
the FC bus via the 4 pin FC connection.
MAC Address
The physical MAC address of the FAC adjustable between 4-127 and is set via
the DIP switch on the front of the unit. When multiple controllers are
connected on the same FC bus, each controller ‘s MAC address must be
unique.
BACnet Instance Number
The BACnet instance number of the FAC is factory-set to a random unique
value from 0-4,194,304. This ensures that every controller will have a unique
BACnet instance number on any possible network.
End Of Line (EOL) Resistor
When an FAC controller is used as a terminator at the end of a FC bus line, the
EOL resistor dip switch can be switched on for best performance.
Fault Light Status
Blink 5Hz - Not all possible room modules are connected. This is normal.
Blink 2Hz - Startup in progress
Off Steady - No Faults
On Steady - No Software
9.2 BACNET IP TO MS/TP ROUTER (ESCO-IPN)
Figure 18:
The BACnet IP to MS/TP Router exchanges information between networks
and allows the controller to communicate on an IP network. One router is
required for each MS/TP network.
The BACnet router has a USB 2.0, Type B receptacle which is only used to
obtain power from a computer or USB adapter. A mains adapter and cable is
supplied.
The router connects to the FC bus via screwed terminals.
Address Type Default Address
IP Address 192.168.92.68
Subnet Mask 255.255.255.0 (/24)
A reset switch is available inside a small hole located on the side of the case.
If you press the reset switch with a paper clip (or similar device) for at least 1
second, the switch resets to the default values of the IP address, gateway
address, and netmask. After you use the reset switch, you need to reboot the
router. The BACnet/IP to MS/TP Router contains a Web server. You can access
the Web server from any Internet-compatible computer on the local network
To configure the router, you need a computer with an Ethernet connection,
router, and standard Web browser.
9.3 INTERCONNECTION
The FC bus connects via the following MSTP cabling:
ESCO-MSTPC30M Ecosmart Connect MSTP cable reel 30m
ESCO-MSTPC150M Ecosmart Connect MSTP cable reel 150m
Suggested Wiring Colouring
White +
Green -
Black COM
Red Unused
Note: On the SA Bus, the + and - wire are one twisted pair, and the COM and
SA PWR are the second twisted pair of wires.
These cannot be used with RJ12 connections and must be stripped and
connected using screwed terminals. The shield must be earthed at the control
panel end only and be made continuous along the bus length.
Room Modules must not be fitted more than 150metres (cable length) from
the controller.
(MS/TP)