NTT docomo P-01C, Инструкция по эксплуатации

Страница: 19 / 155

Basic Operation
17
Attaching UIM (FOMA Card)/ Battery Pack
Before Using
⿠
Ensure that you turn off, close, and take hold of the
FOMA terminal when you install or remove the UIM
or battery pack.
⿠
You cannot use the UIM (blue) on your FOMA
terminal. If you have that blue one, have it replaced at
a docomo Shop.
About UIM
The UIM is an IC card that holds your
information such as phone numbers. You cannot
use the FOMA terminal for communications such
as voice/videophone calls, i-mode, or sending/
receiving mail, unless the UIM is inserted.
Insert the UIM.
With the golden IC surface
downward, push the UIM slowly to
the end while pressing surface.
⿠
Take care not to damage the IC
portion.
When you remove the UIM
⿠
Pull it out slowly while sliding.
2 Cut
Remove the back cover.
While pressing the
surrounding part of “
” of
the back cover, slide the back
cover (2 mm or more) in the
direction of the arrow to unlock and remove it.
1
Attach the battery pack.
With the arrow mark facing
up, securely attach the battery
pack through the dents of the
FOMA terminal, and then push
the battery pack in direction
B while pressing it against
direction A.
When you remove the battery pack
Lift the battery up using the projection of it.
3
Attach the back cover.
With the back cover stayed
open about 2 mm, match it
to the groove on the FOMA
terminal. Then slide the back
cover in the direction of the arrow to install.
⿠
Confi rm there is no gap between the back cover
and the FOMA terminal.
If it is not completely closed, you may hurt your
hand or fi ngers because it is made of metal.
4
Approx. 2 mm
Projection
Arrow mark
Dents