NTI UNIMUX SERIES USB KVM SWITCH
17
8)
Change Volume for Audio Output/User (not applicable to this model)
- change Audio port output volume
9)
Read Connection for Output/User
- read what input is connected to the specified output
a)
Read Connection for Audio Output/User (not applicable to this model)
- read what input is connected to the specified output
b)
Read Mute Status and Volume for Audio Output/User (not applicable to this model)
- read the volume and the mute status of the specified output
c)
Read Unit Size
- read the switch size (number of inputs and outputs)
d)
Read Unit Version/Revision String (not supported by this model)
- read a string containing the switch version, type, and size
e)
Save I/O Connections into Unit Memory (not applicable to this model)
- save the connections into switch memory bank
f)
Restore I/O Connections from Unit Memory (not applicable to this model)
- restore the connections from switch memory bank
g)
Save All Units I/O Connections into Units Memory (not applicable to this model)
- save the connections into switch memory bank, command for all switches
h)
Restore All Units I/O Connections from Units Memory (not applicable to this model)
- restore the connections from switch memory bank, command for all switches
i)
Change All Units Baud Rate (9600/COM1)
- change RS232 Baud rate of all switches
- the current baud rate and serial port are displayed in parentheses
ETHERNET OPERATIONS (not applicable to this model)
SETUP OPTIONS
1)
select Com port current: (COM1:)
- select PC serial port
- the current PC serial port is displayed in parentheses
2)
select Baud rate current: (9600)
- select PC serial port baud rate
-
the current baud rate is displayed in parentheses
3)
set unit Address current: (1)
- select the unit address of the switch to be connected to by this program
- the current address is displayed in parentheses
For any selection that requires user input, the user is prompted. When commands are sent to the UNIMUX, the command string
and UNIMUX responses are echoed to the screen. All commands generated by the program are formatted according to the
information provided in sections above. If any transmission problems are detected, an error message is displayed.
Press <
Esc
> or <
Enter
> to back out to the main menu and press again to exit.
