NTI UNIMUX SERIES USB KVM SWITCH
11
Selects a specific
port
Configure port to connect
To a MAC CPU
Configure port to connect
To a WINDOWS or SUN
CPU
Exit Command Mode
Scan Mode
To activate Scan Mode, press <
S
> from the Command Mode menu.
When in Scan Mode the switch scans to each port with a
CPU powered-ON. (The SCAN LED on the front panel will illuminate and remain ON while in Scan Mode. ) The port with the CPU
powered-ON remains active while in use until it becomes idle for the configured dwell time (default time-out period is 5 seconds)
before switching to the next powered-ON CPU port. See Command Mode section above for configuring the scan dwell time.
To deactivate Scan Mode, press <
S
> from the Command Mode menu again.
Note: The keyboard and mouse must remain idle for the full scan dwell time before the switch selects the next active
port.
Broadcast Mode
To activate Broadcast Mode, press <
B
> from the Command Mode menu. (The BROADCAST LED on the front panel will
illuminate and remain ON while in Broadcast Mode.) Broadcast Mode enables the user to type characters to all powered-ON
CPUs simultaneously. To deactivate Broadcast Mode, press <
B
> from the Command Mode menu again.
Note: The user must type somewhat slowly when in Broadcast Mode (less than 20 wpm) and cannot use the
<Backspace> key
.
Normal Mode
When all of the UNIMUX mode LEDs are OFF the user is in Normal Mode, controlling the CPU to which the user is connected
through the UNIMUX.
No Sun Sleep Mode
Note: It is necessary to configure a Sun CPU (most versions) such that the Sleep Mode is not enabled. If the Sun CPU
goes into Sleep Mode either automatically or manually, the user must reboot the Sun CPU in order to resume use of the
Sun CPU.
To disable the Sleep Mode, perform the following steps:
1.
Select "Power Manager"
2.
Look for "Device Idle Time Before Power Saving Starts"
3.
Select "Always ON"
4.
Look for "Override Device Idle Time For:"
5.
Make sure neither "Monitors" nor "Disks" are selected.
P -
-
(Pxx would be P01, P02, etc.)
(0-9)
x
(0-9)
x
Esc
FYI: The user must exit Command Mode to type to a CPU.
To exit Command Mode, either hold down any touch-switch on the
front panel for more than 2 seconds, OR press <ESC> on the
keyboard.
