NTI VEEMUX AUDIO/VIDEO MATRIX SWITCH
6
Connect to the Ethernet
If the Telnet Interface (page 14) or Web Interface (page 22) will be used, an Ethernet connection to the Local Area Network (LAN)
must be made using Cat5 cable with RJ45 connectors attached. Wiring between connectors should be straight through (pin 1 to
pin 1, pin 2 to pin 2, etc..) Connect a Cat5 cable between the connector labeled "ETHERNET" and the LAN (see Fig. 4).
Figure 4- Connect the LAN to the VEEMUX-A
Power Up
1.
Plug the VEEMUX-A to an AC power outlet.
2.
Turn ON power to the VEEMUX-A.
3.
Turn ON power to any or all of the video and/or audio sources connected to the VEEMUX-A.
LED MATRIX
(not available on all models)
The LED Matrix is a grid of LEDs on the front panel of the VEEMUX-A. This grid is used to provide a visual indication of all
connections between video sources and destinations. It is not an indication of audio connections. To determine if an input
(video source) is connected to an output (video destination), follow the LEDs down and to the right (respectively) until they
intersect. The illuminated LED at the point of intersection indicates the input is connected to the output by the VEEMUX-A.
Figure 5- LED Matrix showing input 5 connected to output 5
1
5
8
1
2 3 4
6
7 8
2
3
4
6
7
5
OUT
IN
MONITOR 1
MONITOR 2
MONITOR 3
MONITOR 4
VIDEO 1
VIDEO 2
VIDEO 3
VIDEO 4
VIDEO 5
VIDEO 6
VIDEO 7
VIDEO 8
R
S
2
3
2
MONITOR 5
MONITOR 6
MONITOR 7
MONITOR 8
NTI
NETWORK
TECHNOLOGIES
INCORPORATED
Tel:330-562-7070
Fax:330-562-1999
1275 Danner Dr
Aurora, OH 44202
www.nti1.com
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
AUDIO IN (CPU)
AUDIO OUT (USER)
ETHERNET
RJ45 male
connector
LAN
Rear View of VEEMUX-A
