NTI MINI SERVER ENVIRONMENT MONITORING SYSTEM
10
Connect the Power
Note: Sensors should be connected before supplying power to the ENVIROMUX-MINI.
1. Connect the AC adapter to the connection marked "PWR" on the ENVIROMUX-MINI and plug it into an outlet.
Figure 7- Connect the AC adapter and power-up
2. Use the NTI Discovery Tool (page 13) to configure network settings.
Connect a Modem
Note: This feature requires firmware version 1.31 or higher to use ENVIROMUX-GSM(A)-P (Teltonika CM1100 or Multitech
MTCBA-G-F4), or version 1.36 or higher to use ENVIROMUX-3G (NetComm N3GS003).
A Serial GSM modem may be connected (ENVIROMUX-GSM-P / ENVIROMUX-GSMA-P) or a 3G Serial Modem (ENVIROMUX-
3G) to use to send SMS alert messages to a contact’s cell phone.
•
The ENVIROMUX-GSM-P and ENVIROMUX-3G modems will connect to the ENVIROMUX-MINI at the “RS232” port
using a CAT5 patch cable and a NTI DB9M-RJ45F-EM adapter (supplied with modem). (See Figure 8.)
•
The ENVIROMUX-GSMA-P modem will connect at the “RS232” port using the 15HDM-RJ45F-EM adapter (supplied with
modem).
The phone number of the contact person can be configured on the sensor configuration page (page 21).
Note: A Mini SIM card (not included) must be installed in the modem for the modem to send messages.
Figure 8- Connect a Modem
Note: The RS232 port is also used to perform firmware updates (page 28). The RS232 port is not used for configuration
purposes.
5 V D C
A C
A D A P T E R
R S 2 3 2
E T H E R N E T
F A U L T
S E N S E S E N S E
W A T E R
C O N T A C T S
+ 5 V
1
2
3
4
+ 5 V
+ 5 V
+ 5 V
E N V I R O M U X
T M
N T I
R
N e t w o r k T e c h n o l o g i e s I n c
T E M P E R A T U R E / H U M I D I T Y
F r o n t V i e w o f E N V I R O M U X - M I N I
5 V
2 . 0 A
A R E A A L E R T
T M
P W R
B a r r e l
( I n s i d e
b a r r e l )
( O u t s i d e
b a r r e l )
P o w e r C o n n e c t o r
2 . 1 m m x 5 . 5 m m F e m a l e
5 V D C @ 2 . 0 A O U T P U T
Note: The power
connector for the
ENVIROMUX-MINI-IND
has a 2.5mm x 5.5mm
female barrel
