NTI AG LinMot E1000 Series, Руководство по установке

Страница: 12 / 12

Controller Series E1000/2000/4000
NTI AG Installation: E1000/E2000/E4000 series / 16.09.2005 Page 12/12
Error codes
Error display When an error occurs it is displayed by means of the blinking of at least one of the four
LEDs on the front of the servo controller.
Ready LED The Ready LED is ON as soon as the supply voltage for the processor is guaranteed and
the system has started up correctly. Communication with the PC over the serial interface is only
possible when this LED is ON.
The following table summarizes the blink codes and their meaning:
F
LED Description
Fault Stat A Stat B
l
l l
l
~ 3Hz
HW system error: Hardware error in the servo controller.
2x
l l l l
~ 1Hz
SW1 System error: Software error in the servo controller. The system
software wasn’t loaded successfully.
l
l l
l
~ 1Hz
off off
SW2 System error: Software error in the servo controller. The system
software wasn’t loaded successfully.
On
l
l l
l
~ 2Hz
l
l l
l
~ 2Hz Generic fault: The exact error message may be displayed
with the error inspector.
2x
l l l l
The supply voltage for the Power circuitry is too low.
3x
l
l l
l
The supply voltage for the Power circuitry is too high.
4x
l
l l
l
The supply voltage for the Signal circuitry is too low.
5x
l
l l
l The supply voltage for the Signal circuitry is too high.
n
6x
l l l l
The servo controller is too hot.
8x
l l l l
Application Software Error (see Manual)
1x
l
l l
l
The motor is overloaded.
2x
l
l l
l The motor is too hot.
3x
l l l l
Following error.
4x
l l l l
The slider is missing from the motor.
6x
l
l l
l The initialization was not completed successfully.
7x
l l l l
Incorrect motor type configured or damaged motor.
On
1x
l
l l
l
: Mot A
2x
l l l l
: Mot B
3x
l
l l
l
: Mot C
4x
l l l l
: Mot D
8x
l l l l
A referenced motion profile for a motor is missing. Selected motion
profile not valid for actual drive type.
on LED is ON
l
LED blinks shortly (ca. ¼s)
off LED is OFF
n
LED blinks longer (ca. 1½s)
Contact Addresses
NTI AG
LinMot Tel. +41 (0)56 419 91 91
Haerdlistrasse 15 Fax. +41 (0)56 419 91 92
CH-8957 Spreitenbach email: office@LinMot.com
Switzerland Web: www.LinMot.com
LinMot Inc .
N2444 Broad Street Phone +1-877-546-3270 or 262-728-2699
Delavan Fax: +1-800-463-8708 or 262-740-0141
WI 53115 email: officeUS@LinMot.com
USA Web: www.LinMot.com