NSS SWIFTVAC 6, Руководство по эксплуатации, Страница: 6 / 16

MACHINE OPERATION
With the switch in the off position, plug the electrical
cord into an approved outlet (See page 3). Turn on the
machine with the switch located on the right side of the
machine.

Attachments may be added for overhead cleaning
in such applications as removing dust from tops of
door and window frames, walls and ledges.

Brush and upholstery tools may be added to aid in
hand work. Select the proper tool for the maximum
cleaning result.

When using the machine on floors, the operator
should drop their arm slightly to allow air to enter
the front edge of the tool on the forward stroke. On
the backward stroke the operator should raise their
arm slightly to allow the back edge of the tool to
clear the floor. This method gives the air a chance
to do the work in the most effective manner.

The operator should make strokes at a leisurely
pace and at a length that feels the most natural.
INTENDED USE
NSS vacuum cleaners are intended for commercial
use, vacuuming floors, furniture, and draperies in an
indoor environment. This machine is intended for Dry
pickup only. NSS does not recommend using these
machines for any other purpose.
STORAGE
Disconnect the power cord from the wall outlet. Wrap
the power cord around machine. Lift the machine off
the floor and onto a table or shelf. Install a new
disposable paper HEPA filter bag as required. Make
sure the power switch is in the “off” position.
MAINTENANCE
Routine maintenance is critical to ensure proper
machine operation and cleaning performance.
Perform all maintenance procedures as follows:
Always unplug machine before performing any
maintenance. See page 3 for warnings.
Daily Maintenance

Inspect the cord, plug, and switch for any damage.

Remove the hose from the machine at the end of
each workday. The tube handle should be
removed from the hose and the hose should be
laid in a loose coil or hung over several pegs on
the wall.
NOTE: To prevent damage to the AC power cord
and vacuum hose, ALWAYS store the machine
with the AC power cord and hose coiled loosely
over the machine. Filter bags must be emptied
and cleaned on a regular basis to prevent loss of
vacuum suction and possible machine damage.
After emptying the filter bag reinstall it back onto
the machine and vacuum the dust from the outside
of the filter bag.
Weekly Maintenance

Verify that all daily maintenance has been done.

Remove tool from tube handle to clean and inspect
for wear.

Inspect the filters, clean or replace.
Monthly Maintenance

Verify that all weekly maintenance has been done.
Every 6 months
Check carbon brushes for wear. When carbon
brushes and copper on the commutator are worn to
1/2" in length (approximately 700 hours), take the
appliance to an authorized NSS service facility for
service/replacement of the brushes.