English
Power Cord Jack
Inlet
Power Lamp
Power Switch
12
13
(1) Charging Batteries
1. Insert the power cord jack into the inlet at the back of the battery charger. (Fig. 1)
2. Insert the power cord and plug in. Make sure you have the correct model/voltage.
3. Turn on the power switch. At this time, check that the power lamp lights up. (Fig. 2)
4. Insert the motor handpiece into the battery charge. Charging starts with the charge mark
flashing on LCD.
5. When the alarm sounds and “ ” is displayed on the liquid crystal panel, charging is
completed.
5. Operations
• BATTERY Symbol
The symbol indicating the battery status is displayed. The symbol will be animated when the
batteries are being charged or in the refresh mode.
: Full charge or nearly full charge
: About 30-80% remains
: Less than about 30% remains
: Batteries are drained or in a remarkably low voltage. Charge the batteries.
• ALARM Symbol
The present alarm symbol is displayed.
: Alarm ON
: Alarm OFF(No display)
When the alarm does not sound and the charging animation is not displayed despite
batteries being replaced with new ones, immediately stop using and contact your dealer.
(Refer to Changing Batteries)
WARNING
The symbol indicating theremaining amount of the batteries indicates a voltage. When
load is applied to the motor handpiece, the symbol indicating the remaining amount of
the battery charge appears to become lower.
NOTICE
Load alarm when the motor rotates and auto reverse sound can be set to ON/OFF.
(Refer to 6 (4) Alarm Sound Volume Control)
NOTICE
No
Display
Fig. 2
Fig. 1
