Page 4
INST2063 - 6/14
4.0
Accessories
4.1
Model 4064 Ionmaster™ II Fan
The Model 4064 Ionmaster™ II Fan is used to create airflow through the Ionizer (model P-2063
Nuclecel™). This system delivers a high volume of ionized air to reduce charge on parts. The
Fan is mounted on a swivel base and can be placed on a flat surface or bolted to a rigid surface.
Procedure to install a new P-2063 Nuclecel™ Ionizer:
A.
Unplug the power cord before opening the fan assembly.
Remove the two (2) phillips
head screws located on the backside of the fan.
B.
Remove the front housing of the fan.
C.
See the below diagram showing the installation of the P-2063 Nuclecel™ Ionizer. Snap in
the Ionizer by aligning the Ionizer posts with the spring clips. The orientation of the
Ionizer does not matter since it is symmetrically designed.
D.
Re-assemble the front blower housing and tighten the two phillips head screws.
Tightening the screws will secure the ion cell inside the fan assembly.
E.
Position the Fan Assembly to direct air where it is needed. The airflow is directed up and
down by loosening (counterclockwise) the two black knobs, repositioning, and re-
tightening the knobs to secure fan position.
F.
Plug the power cord into a 120 VAC grounded outlet. Turn on the power switch located
on the top panel.
two (2) phillips
head screws
P-2063 Nuclecel™
Ionizer
Front Housing
Spring Clips
