NPort Networks N1-9802W, Руководство пользователя

Страница: 79 / 296

79
[Shutdown]
[Trap&Shutdown]
State
[Disabled]
[Ready]
[Limit Reached]
[Shutdown]
Re-open Button
disabled, only one SNMP trap will be sent,
but with Aging enabled, new SNMP traps
will be sent evert time the limit get
exceeded.
If Limit+1 MAC addresses is seen on the
port, shut down the port. This implies that
all secured MAC addresses will be
removed from the port, and no new
address will be learned. Even if the link is
physically disconnected and reconnected
on the port(by disconnecting the cable),
the port will remain shut down. There are
three ways to re-open the port:
1) Boot the switch,
2) Disable and re-enable Limit Control on
the port or the switch
3) Click the reopen button.
If Limit+ 1 MAC address is seen on the
port, both the
“Trap” and the “Shutdown”
actions described above will be taken
This column shows the current state of the
port as seen from the Limit Control
’s point
of view. The state takes on of four values:
Limit Control is either globally disabled or
disabled on the port
The limit is not yet reached, This can be
shown for all actions.
Indicates that the limit is reached on this
port. This state can only be shown if Action
is set to None or Trap.
Indicates that the port is shut down by the
Limit Control module. This state can only
be shown if Action is set to Shutdown or
Trap & Shutdown
If a port is shutdown by this module, you
may reopen it by clicking this button, which
will only be enabled if this is the case. For