ISO-STIM 01B User Manual
version 1.8
page 8
3.3. Description of the Rear Panel
Figure 2: Rear panel view of ISO-STIM 01B
On the rear panel of the ISO-STIM 01B there is only one SubD connector. This connector is
used to connect the ISO-STIM 01B to its power supply.
3.4. ISO-CAB (optional accessory)
npi provides an optional shielded cable for connection of stimulation electrodes. One end is
equipped with three color coded 4 mm connectors. The red and black connector are connected
to the ISOLATED OUTPUT connectors on the front panel of the ISO-STIM-01 D. Each of
these stimulation lines has a shield which is connected to the common green SHIELD
connector. To reduce noise during recordings, this connector can be connected to the CHASSIS
connector at the ISO-STIM-01 D front panel
The other end of the cable provides open wires, to which different connector types can be
soldered by the user. The red cable is +STIM, the yellow cable is –STIM. The shield is present
as bare wire. Usually, these shield wires are left unconnected on this end of the cable.
Figure 3: ISO-CAB - shielded cable for connection of stimulation electrodes.
