NHDR
-
6004
-
H1, NHDR
-
6008
-
H1, NHDR
-
6016
-
H1, NHDR
-
6116
-
H2
User
’
s manual (Short) ver.1.0
All rights reserved © AAT Holding S.A.
11
STARTING THE DEVICE
After screwing the disks, connect the power and signal cables to the disks.
After connecting the hard disk drive, mount the recorder housing and run it to check the correct
connections and format the hard disk drive.
WARNING:
If the disk used has been used in another device, it must be formatted. The formatting process
results in the loss of data saved on the disk.
2.3. Connecting the power supply.
To start please connect provided power cord in the rear power port of the NHDR. Initialization lasts
approximately 60 seconds. During this time executing any device functions and pressing any buttons is
prohibited. To shut down the device please use the menu.
CAUTION:
Make connection when the power is not applied.
Do not place the power cord under the carpet or rug. The power cord is usually earth
-
grounded.
However, even if it's not earth
-
grounded, never modify it on your own for earth
-
grounding.
Make sure that power adapter is placed near of NHDR and secured from accidental
disconnection.
If the device was brought from a location with lower temperature, please wait until it reaches the
temperature of location it is currently in. Turning the device on immediately after bringing it
from a location with lower ambient temperature is forbidden, as the condensing water vapour
may cause short
-
circuits and damage the device as a result.
Before starting the device familiarize yourself with the description and the role of particular
inputs, outputs and adjusting elements that the device is equipped with.
