NDR-BA2208-II, NDR-BB2208,NDR-BA2416, NDR-BA4104-II, NDR-BB4104, NDR-BA4208
and NDR-BA4416
User’s manual (short) ver.1.3
All rights reserved © AAT Holding sp. z o.o.
22
8. PLAY / PAUSE
pressing the PLAY during “live” mode enters playback mode. Subsequent
pressing pauses the playback.
In PTZ control mode button is used for IRIS adjustment.
9. FF
Consecutive presses in playback mode switch playback speed between FFx1,
FFx2, FFx4, FFx8, FFx16, FFx1/4, FFx1/2.
In PTZ control mode button is used for SPEED adjustment.
10. ESC / STOP
Pressing the button either exits menu or moves to a higher-level menu. When
pressed during playback, leaves playback mode. Holding the ESC switches
OSD menu displaying between VGA and BNC outputs.
11. NAVIGATION BUTTONS
: navigate through DVR menu and change values of particular
parameters
12. IR DETECTOR
IR remote controller receiver. Do not cover.
13. USB
USB 2.0 port for backing up the recordings either to external HDDs or Flash
drives. Length of connecting cable should not exceed 30 cm;
3.2. Controlling via USB mouse
DVR features the possibility of controlling the DVR using an USB mouse connected to the USB port.
Functions described below are available in „live” mode.
Double-clicking on any camera in 2x2, 3x3 and similar display modes switches the display to full-
screen mode. Subsequent double-click returns to previous display mode.
During configuration, selection of particular options is performed via the left mouse button.
Depending on DVR operating mode, pressing right mouse button hides current menu or returns to
previous menu.
3.3. Controlling via IR remote controller
An IR remote controller is shipped together with the
NDR-BA4416, NDR-BA2416, NDR-BB4104,
NDR-BB2208 and NDR-BA4208
DVRs. Range is dependent on the battery level and varies from a few
to a few tens of meters.
If an ID number of the remote controller equals 0 any DVR can be controlled. If two or more DVRs
utilize same ID they will be controlled simultaneously.
To change ID of the DVR please enter the
MAIN MENU / SETUP / BASIC / SYSTEM
and enter
Device
ID
ranging from 0 to 65535. Current ID number may be checked under the
MAIN MENU /
INFORMATION / SYSTEM
.
To change current ID number of the remote:
point the remote in general direction of the DVR,
select and press the “8” channel selection button twice
set the ID of DVR ranging from 0 (default) to 65535
RECORDER’S OPERATION
