4
Parts Of The System
The following components make up your Reverse Osmosis Drinking Water System:
1. Pre-filter (SED-10)
removes larger particles such as sand, silt, and rust.
2. Pre-Carbon Filter (COC-10)
removes chlorine in the feed water to protect the reverse osmosis mem-
brane. Optional CB-10 or GAC-10 filter may also be used
3. Reverse Osmosis Membrane
reduces dissolved minerals, metals and salts. During the process, harmful
compounds are separated by the membrane and the reject water goes to waste (drain).
4. Post-Carbon Filter (COC-10)
is provided for a final “polish” to provide great tasting drinking water.
5. Storage Tank (3.0 Gal)
holds filtered water, ready for use.
6. Self-piercing Inlet Saddle Valve
is connected to the cold water line to supply water to the RO system.
7. Faucet (Standard)
used to dispense RO water when needed.
Optional air gap and designer faucets
are available.
8. Automatic Shut-off Valve
senses when the storage tank is full and closes the water supply to conserve
water.
9. Waste Water Saddle
is connected to the drain to remove reject water from the RO system.
Figure 1. Typical Installation
Installation Steps
1. Cartridge Filters
2. Faucet
3. Self-piercing Inlet Saddle Valve
4. Waste Water Saddle
5. Unit Installation
6. Tubing Connections
7. Flush System and Check Operation
#1
#2
#3
#4
#5
#7
#8
#9
#6
OPTIONAL DRAIN LINES
(AIR GAP FAUCET)
