Novexx AP 5.4 Gen II, Руководство пользователя

Страница: 85 / 408

01/12 Rev. 5.07-01 USER MANUAL Setup
AP 5.4 – AP 5.6
17
2. Make a test printout and check the evenness of the printed results. If the
printing intensity is not even, turn the thumb wheel even further.
3. Repeat steps 1 to 3 until the print intensity is even across the entire label
width.
Parameter settings
For more information on how to set the parameters, see “Info Printouts and Pa-
rameters”, section
Operating the Parameter Menu

.
Material Parameters
Using the following three parameters, you can enter the properties of the label
material to be printed on the printer:
Setting the label length automatically

In offline mode, press the feed+prog buttons simultaneously.
After pressing the button, the printer transports the label material forwards until
two start-of-label markings have passed by the label sensor. The label length
thus determined will be displayed and applied to
PRINT PARAMETERS > Material length . Furthermore,
PRINT PARAMETERS > Material type
is set to “Punched”.
Display of the measured label length:

This function measures the label length without punches, i.e., from the start
of the label to the end of the label. For label material with very large punches,
we recommend measuring the label length manually and then entering this
value (label punch).
Ribbon Parameters Using this parameter, you can configure whether to use direct thermal printing
(without ribbon) or thermal transfer printing (with ribbon).
Parameter Function
PRINT PARAMETERS > Material type
Sets the material type (punched or
continuous)
PRINT PARAMETERS > Material length
Sets the label length (start of label to
end of label)
PRINT PARAMETERS > Material width Sets the material width
SYSTEM PARAMETER > Light sens. type
Sets the sensor type (reflex or trans-
mission) according to material type
(reflex markings or punches)
OFFLINE x JOBS
198.5 mm
Parameter Function
SYSTEM PARAMETER > Foil mode
Set to thermal transfer or direct ther-
mal printing.