Novexx Solutions ALX 92x, Руководство по обслуживанию

Страница: 537 / 824

1. Only 64-xx dispenser with 4“ printhead 2. Only if SYSTEM PARAMETER > Ribbon autoecon. = „On“, „On Turbo“ or „Thermal/headlift“ 3. Only with 8-Dot-Emulation 4. Only with 64-08 5. Only with rewinder option 6. Only with cutter 7. Only
with USI interface 8. Only if SYSTEM PARAMETER > Gap detect. mode = Autom. feed back 9. Only with at least one data block stored in the flash memory 10. Only if SYSTEM PARAMETER > Print Interpret. = „ZPL Emulation“ 11. Only with I/
O board 12. Only if PRINT PARAMETERS > Punch mode = Manual 13. Only in production mode 14. Only with 64-xx dispenser 15. Only if SYSTEM PARAMETER > Autom. dot check = Continuous 16. For details read parameter description 17.
Only with 64-04/05/06 18. Only with installed RFID option 19. Only if DP INTERFACE > Interface type = USI Applicator 20. Only with SYSTEM PARAMETER > Dispensing edge = „User defined“ 21. Not with 64-xx dispenser 22. Only with an
activated RFID option 24. With connected remote display only 25. With Applicator Interface only 26. Only OLV option activated 27. Depends on the applicator type 28. Only if INTERFACE PARA > NETWORK PARAM. > WEB server = „On“ 29.
Availability depends on device conf. 30. Only with a CF card inserted 31. Only with a WLAN CF card inserted 32. Only if INTERFACE PARA > NETWORK PARAM. > Time client = „On“ 33. Only if SYSTEM PARAMETER > Periph. device = „Tear-
off edge“ 34. Only if SYSTEM PARAMETER > Periph. device = „Dispenser“ 35. Only if DISPENSER PARA > Transport mode = „Dual motors“ 36. Only if DISPENSER PARA > Speed Adaption = „On“ 37. Only if DISPENSER PARA > Multi label
mode = „x labels/start“ 38. Only if DISPENSER PARA > Multi label mode = „3 labels/start“ 39. Only PEM 39. Only if CPU board index is -06 or lower
05/16 Rev. 03 USER- / SERVICE MANUAL Info-Printouts & Parameters
64-xx – DPM – PEM – ALX 92x – ALX 73x (PMA)
15
64-xx Oper
at
or
Pa
ra
m
et
er
s
64-xx operator parameters
PRINT PARAMETERS SYSTEM PARAMETER DISPENSER PARA 14 SPECIAL FUNCTION SERVICE FUNCTION SERVICE DATA
Print speed Light sens. type Dispenseposition 14 Delete job Head dot test > MODULE FW VERS.
Feed speed Ribbon autoecon. Start offset 14 Delete spooler Matend tolerance System version
Material type Ribbon eco. limit Store Parameters System revision
Material length Print contrast Store Diagnosis System date
Material width Bootloader
Print direction uMon
Cut speed 6 Feed driver
Cut position 6 Foil driver
Double cut 6 Head driver
Rewind direction 5 Peripheraldriver 29
X – print offset Rewinder 29
Y – print offset USI interface 29
Dispenser lift 29
Dispenser feed 29
> OPERATION DATA
Serv. operations
Headnumber
Roll number
Cutter number
6
Head run length
Roll run length
Cuts on knife
6
Tot. mat. length
Tot. foil length
Total cuts
6
Total head moves
Head strobes
F
W
6.60