Novanta JADAK JE-238, Руководство пользователя

Страница: 24 / 80

JADAK JE-238 User’s Manual Page 23
Aimer Mode
The JE-238
’s imager is equipped with an aimer that can help with positioning barcodes for
quicker decoding. Scan one of the following codes to enable or disable the aimer of the scanner,
during decode attempts. Default = Enabled.
*
Enable Disable
Aimer Delay
The JE-238
’s aimer allows a delay time for the user to aim the JE-238 at the barcode before
actual scanning begins. During this delay, the aiming light will appear, but the sc
anner’s
illumination will not show, until the delay time has passed.
This command sets the Aimer Delay Time in steps of one millisecond from 1ms up to
4000ms (4 seconds). Default = Off.
Several commonly used Aimer Delay menu command barcodes are included below.
If a different delay time other than those provided is needed, it can be set either by sending
the serial command
AIM_DLY x
(where ‘x’ is a value between 0 and 4000), or by scanning
the top barcode below and then set the time by scanning the digit codes and the SAVE
barcode in Appendix B . Please contact JADAK if assistance is needed.
Sample settings:
* Aimer Delay Off Aimer Delay = 500ms
Aimer Delay = 1000ms Aimer Delay = 2000ms