NovaLynx Corporation________________________________________________________________________________
200-WS-21-A
Page 10
November 2018
1.
Tighten the mounting screws if necessary (do not strip the threads in the plastic base of the
sensor).
2.
Spin the anemometer cup assembly. It should turn freely. A short spray of light oil such as
WD40 can be applied to the bearing located in the hub of the cup assembly.
3.
Inspect the cable and ensure it is secured to the mast to prevent damage due to wind whipping.
4.
A repair kit (Part number 2502-14-10B) is available in case one of the cup arms is broken.
6
WIND ALARM CONTROLLER INSTALLATION
6.1
Controller Location
To be effective the Wind Alarm controller must be in a location where one can view the display and hear
the alarm. At the same time it should not be accessible to unauthorized personnel. It will need to be
mounted near a 120VAC receptacle for power. If the controller is inside a building the sensor cable will
need to be routed outside so that the sensor can be exposed to the wind.
6.2
Controller Mounting
There are 4 knock-out locations inside the controller box for placing screws. It will be necessary to remove
the controller to access these points. After mounting the case to your wall or panel, use the provided caps
to cover the screw locations. This will help keep moisture from entering the box. Replace the controller
circuit board and secure it with the mounting screws.
