8
|
Novak Electronics, Inc.
www.teamnovak.com
INSTRUCTION MANUAL
NOVALINK INSTRUCTIONS
Startup
1.
Make sure to have your USB cable, NovaLink USB Adaptor, and ESC
ready
2.
Plug the USB cable into your computer’s USB port
3.
Plug the NovaLink adapter into the USB cable
4.
Unplug the two input harnesses from your receiver
(Figure 1)
5.
Unplug the ESC fan & battery
6.
Plug the throttle harness into the NovaLink adapter (Figure 2)
7.
Start the NovaLink program
8.
If you are ready to upload and configure your ESC settings, refer to the
Uploading
/Updating a Profile
section
Always unplug the
ESC fan
AND
battery
before running NovaLink or the ESC
Firmware Upgrade! (refer to
Precautions
for details)
NOTE: Make sure you unplug both input harnesses before starting the
NovaLink software!
Any time One-Touch programming is performed, the speed controller will automatically revert back to factory-
default settings. The only exception is when the Timing settings are programmed via the NovaLink. These
settings are kept in the ESC’s non-volatile memory and when you connect the ESC to the NovaLink, the
following values will be uploaded from the ESC non-volatile memory:
-
Timing Set Point
-
Max Timing RPM
-
Timing Level
-
Boost Mode
-
Boost Delay
When the ESC is powered up it goes through the following sequence:
1.
All five LEDs light up during an internal test cycle.
2.
Blue
and
green
LEDs light up while the ESC is looking for the NovaLink. During this time, it is sending
out messages through the input harness and is expecting a return message from the NovaLink. If no
messages are received by the ESC, it times out.
3.
Red
and
yellow
LEDs blink twice to indicate Li-poly mode.
4.
If the ESC is connected to a receiver and the signal is present, the
red
,
yellow
and
blue
LEDs light up
to indicate that the Neutral PPM signal is present and the Drag brake is enabled (if Timing is enable,
the
white
LED will also light up).
5.
If no signal is present, the
red
and
green
LEDs will light up.
Figure 1
Figure 2
Содержание M2 DIG - V1.0
Страница 1: ...INSTRUCTION MANUAL Version 1 0 12 15 2010...