NOVAK M2 DIG - V1.0, Инструкция по эксплуатации

Страница: 14 / 16

14
|
Novak Electronics, Inc. www.teamnovak.com
INSTRUCTION MANUAL
- This feature auto-selects the correct voltage cut-off value for the
number of cells in the main battery pack once the correct battery
type is selected.
WARNING : ALWAYS USE VOLTAGE CUT-OFF WITH LiPo AND LiFe
BATTERY PACKS. IF VOLTATGE CUT-OFF CIRCUITRY IS TURNED OFF AND
BATTERIES ARE ALLOWED TO DISCHARGE BELOW THE CELL’S CRITICAL
VOLTAGE, BATTERIES WILL BE DAMAGED.
Note: This feature is not accessible when the speed control is disconnected.
Operation Mode
Dig Mode
Default setting. When the transmitter’s AUX/3
rd
switch/dial is
thrown, the dig function for either the front or rear motor
(depending on the switch position) will be engaged, and the ESC
applies Dig Power (independent of Drag Brake) to lock the motor.
This mode requires a 3-channel transmitter with either a
proportional AUX/3
rd
channel switch or a simple three-position
switch to operate.
Proportional Dig Mode
In this mode, for any given partial throttle position, the
percentage of drive power applied to the affected motor is
reduced as the position of the AUX/3
rd
channel increases, while
the other motor receives its full amount of drive. When the
AUX/3
rd
channel nears full throw, the preset Dig Power is applied
to lock the affected motor. This mode requires a 3-channel
transmitter with a proportional-style AUX/3
rd
channel switch or
control similar to a dial or a knob.
Single Output Mode
This mode is used for standard 2-channel operation with either
single or dual-motor control. There is no dig function in this
profile.