Notifier AIM-200, Руководство пользователя, Страница: 9 / 60

9
Document 15949 Rev. E 4/12/95 P/N 15949:E
Section Three: Installation
This section outlines the installation procedure for the AIM-200. For information on install-
ing other System 5000 equipment and power limited wiring, refer to the Installation Manual,
Document 15583.
3.1 Installing the AIM-200
Complete the following steps to install the AIM-200 onto the CHS-4 Chassis.
1) Mount the AIM-200 to a CHS-4 Chassis.
2) Insert the tab on the bottom of the AIM-200 into the slot on the bottom of the CHS-4.
3) Fasten the AIM-200 to the top of the CHS-4 using the two captive screws in the top
corners of the module. Refer to Figure 3-1.
4) Connect the ribbon cable. See Figure 3-2.
Note: If point annunciation (192 intelligent AIM-200 points and 56 standard system circuits)
of a single AIM-200 is desired, the AIM-200 must be mounted in the second slot of the
first chassis (directly to the right of the CPU). This annunciation option must also be
selected in system programming.
Connecting the Alarm Bus Cable
Connect the alarm bus cable following the steps below. Use the alarm bus cable (Part No.
71033) included with the AIM-200.
1) Remove the 2-pin connector on one end of the cable.
2) Separate and strip the wires, leaving about half an inch of bare wire exposed.
3) Connect wires to Terminals 14 and 15 on the CPU.
4) Connect the other end of the trouble cable to the left-most 2-pin terminal on the
bottom left-hand corner of the AIM-200. If additional AIM-200s are employed, see
Figure 3-3.
AIM-200 CHS-4
A IM -2 0 0 C H S -4
Figure 3-1: Mounting the AIM-200
Technical Manuals Online! - http://www.tech-man.com