19
11. Slowly lower the blade by rotating the hand wheel clockwise until the
desired depth of cut is reached. Use a reasonable rate of feed. A
reasonable rate of feed will depend on depth of cut, material, and blade.
Normal cutting speeds should be between 2 ft/min in very hard material
and up to 10 ft/min in softer materials. Do not force the blade in to the
cut! If the engine begins to stall or the saw raises out of the cut slow the
forward speed down!
12. If the engine begins to stall or the saw raises out of the cut slow the
forward speed down!
13. When moving the saw to a new location, be sure the blade is not
touching the ground. Always pay close attention to where you are
moving and where the blade is at all times.
13. When the end of the cut is reached, slowly raise the blade out of the cut
by rotating the Hand Wheel Clockwise until the blade is at least one (1)
inch above the ground.
14. To move the machine in reverse raise the blade out of the cut and pull
back on the machine. Only move the saw in reverse with the blade in the
raise position.
15. When moving the saw to a new location be sure that the blade is not
touching the ground and always pay close attention to where you are
moving and where the blade is at all times.
Caution:
Do Pull The Machine Backwards While The
Blade Is In The Cut As The Blade May Be Damaged.
H. Cutting Technique
Lower the blade into the concrete to the required depth by turning the hand
wheel clockwise. Ease the handle slowly forward. Retard the forward
pressure if the saw begins to stall. Note: For deeper cuts (4 inches or more),
several cuts should be made in incremental steps of 1-1/2 to 2 inches until the
desired depth of cut is reached. Push the saw steadily forward using the front
pointer as a guide. Exert enough forward pressure so that the engine begins
to labor, but does not slow down. If the saw begins to stall, retard the forward
movement until full rpm is restored to the blade. If the saw stalls, raise the
blade out of the cut before restarting. Avoid excessive side pressure or
twisting of the blade in the cut.
Содержание C1320P
