NorthStar 1201, Руководство пользователя

Страница: 26 / 52

Page 22 — Installation 1200 Series Display, Rev. A2
Installation
In order to enjoy trouble-free installation and operation of your
display, Northstar recommends that you use the services of a
professional marine electronics installer. The installer should
review and check off each applicable step in the Installation
Checklist included in Appendix A (page 44) of this manual.
WARNING:
Be sure to turn the power off at the main
circuit breaker panel before starting the
installation. If power is applied during
the installation, fire, electrical shock, or
other serious injury may occur.
WARNING:
Connect the display only to a power
source between 10 and 36VDC. Voltages
outside of this range can result in fire or
damage. Ground equipment properly in
order to prevent electric shock or mutual
interference.
WARNING:
Be sure to use only 7 Amp fuses. Using
the incorrect fuse values can result in
fire or damage to the display. The 1201
and 1202 both use 7 Amp external fuses.
WARNING:
If the power cord must be shorter, make
sure to keep the external fuses intact.
If the power cable must be longer than
that supplied, use a heavier gauge wire.
In all cases, make sure to use 7 Amp
external fuses on both positive and
negative power leads.
!
!
!
!