Northern Tool 168650, Руководство пользователя

Страница: 9 / 14

8
ASSEMBLING THE POWER SWITCH
WARNING! Do not use sharp tools when assembling the power switch, as
they may damage the insulation on the wires.
If you are unfamiliar with electrical work, contact a professional electrician
to perform the installation.
The ON/OFF power switch (W) is located in the upper corner of the stand. Attach
the switch to the side of the steel stand using two nuts, bolts and washers (X).
NOTE: Be sure ON is at the top. (Figure 12)
Take the single black power cord and insert the black, white and green wires
through the three parts of the cable bushing (Y) before inserting them through the
front panel of the stand. (Figure 13) Do not tighten the bushing until the wires
are connected to the proper terminals. Once the wires are inserted through the
front panel, insert them through one of the holes in the switch cover. (The cover has
been removed in Figure 13 to better show the connections to the terminals.) Be sure
the clear plastic insulation stays with each wire. Once the wires are through, pull
some of the black cable through as well. This will make it easier to connect the wires
to the terminals.
Insert the black, white and green wires coming off the motor into the other hole in
the switch cover.
Attach the black wires to the terminals on one side of the switch, and the white
wires to the terminals on the other side. The green Ground wires are connected
directly to the steel side panel with a nut, bolt and washer on each. The Ground
symbol is located in the center of two holes, which are covered by stickers.
Remove the stickers, insert a bolt with the ground wire attached through each, and
apply the washer and nut. Once tightened, the Ground wires use the steel structure
of the machine to ground the electric. (Figure 13)
Attach the switch cover (Z) to the steel cabinet with nuts, bolts and washers, and
tighten the cable bushing (AA) by hand. (Figure 14)
Attaching the Stainless Steel Table
WARNING! Use caution when guiding the table past the saw blade as
serious injury may occur. Wear protective gloves.
Assembling the Power Switch
WARNING! Use caution when guiding the table past the saw blade as serious injury may occur. Wear
protective gloves.
Remove the four socket screws from the table support as described on Page 6 (Figure 3). Then, from the left
front side of the machine, hold the table in both hands and guide it up onto the two table guide wheels (BB)
(Figure 15) on that side. The wheels should fit the rails which are already attached to the underside of the table.
Guide the table across the top of the machine to the guide wheels on the opposite side. Once the table is in
place, reattach the table support.