North SELEKT BRD, Руководство по эксплуатации

Страница: 12 / 32

INSTALLATION
May 06, 2020 Page 12 User Manual No: OM-101A EN
SECTION 4 –
INSTALLATION
4.01
Environmental Limits
These air or water cooled MIG/MAG Manual Welding
Torches are designed for use in environments where:
• Operating temperature range is -10 °C to +40 °C
(+14 °F to +104 °F)
•
Relative air humidity during operating is 0% to 90% @
+ 20 °C ambient air temperature
4.02
Torch Operation Guidelines
Be sure to locate the MIG/MAG equipment according to
the following guidelines:
• In areas, free from moisture and dust.
• In areas, free from oil, steam and corrosive gases.
• In areas, not subjected to abnormal vibration or shock.
• In areas, not exposed to direct sunlight or rain.
Torch installation must be
done by a suitably Trained
and Qualified Tradesperson.
Disconnect power to
MIG/MAG equipment. Elec-
tric shock can kill.
Flying metal or
dirt can injure
eyes.
FUMES and Shielding
GAS can be hazardous
to your health.
Moving parts
can cause in-
jury.
Sparks, weld spatter or
hot work piece can
cause fires and burns.
Improper instal-
lation can cause
fire.
Read User
Manual.
Genuine JINAN NORTH WELDING TOOLS parts must be used for safety and performance reasons or the warranty becomes
invalid.
Inspect all parts for transportation damage. Do not use damaged parts.
4.03
Connecting Power Pin to Adaptor
BZL Euro, TWE Euro, BRD Euro Power Pin Connector Block to Euro Adaptor
1 Disconnect power to the MIG/MAG equipment.
2 Align Euro Power Pin Connecter Block with Euro Torch
Adaptor then insert it.
3 Secure tighten the Connector Nut into the Euro Adaptor .
4 Refer to the MIG/MAG equipment user manual for feeding
the welding wire into the MIG/MAG Manual Welding
Torch.
PNA Power Pin Connector Block to PNA Adapter
1 Disconnect power to the MIG/MAG equipment.
2 Insert the Power Pin into the Torch Adaptor to shoulder then se-
cure using mechanical means as described in MIG/MAG equip-
ment user manual.
3 Connect then secure the control plug and gas hose into MIG/MAG
equipment.
4 Refer to the MIG/MAG equipment user manual for feeding the
welding wire into the MIG/MAG Manual Welding Torch.
TWE Tweco ® Power Pin Connector to Tweco ® Style Adaptor or TWE Lincoln ® Power Pin Connector to Lincoln ® Style Adaptor or TWE Miller ®
Power Pin Connector to Miller ® Style Adaptor
1 Disconnect power to the MIG/MAG equipment.
2 Insert the Power Pin into the Torch Adaptor to shoulder
then secure using mechanical means as described in
MIG/MAG equipment user manual.
3 Connect then secure the control plug into MIG/MAG
equipment.
4 Refer to the MIG/MAG equipment user manual for feeding
the welding wire into the MIG/MAG Manual Welding
Torch.
BRD Miller ® Power Pin Connector to Miller ® Style Adaptor
1 Disconnect power to the MIG/MAG equipment.
2 Insert the Power Pin into the Torch Adaptor to shoulder
then secure using mechanical means as described in
MIG/MAG equipment user manual.
3 Connect then secure the control plug into MIG/MAG
equipment.
4 Refer to the MIG/MAG equipment user manual for feeding
the welding wire into the MIG/MAG Manual Welding
Torch.
Disconnect