SPOOL TORCH: Installation and Operation
May 25, 2022
Page 15
User Manual No: OM-10
4
A EN
4.05
SPOOL TORCH: How to Feed Welding Wire
MODEL: QLBF-24D and QLBF-36D
a) Connect MIG/MAG Spool Torch as per Section 4.03 then fit the
Welding Wire Spool
as per
Section 4.04 for QLBF-24D or QLBF-36D.
b) Remove
Nozzle (1)
.
c) Remove
Contact Tip (2)
.
d) Connect power to the MIG/MAG equipment.
e) Depress
Torch Trigger Switch (9)
to energizes welding power to drive
Welding Wire
thru the
Swan Neck
.
f) Release
Torch Trigger Switch (9)
when
Welding Wire
emerges from the
Swan Neck
.
g) If
Welding Wire
slips on the Drive Roll (
Welding Wire
does not feed constantly from Torch)
then adjust
Pressure Arm Screw (8)
in a counter-clockwise direction where the
Welding
Wire
is not slipping. DO NOT over tighten the
Pressure Arm Screw (8).
h) Fit
Contact Tip (2)
and secure.
i) Fit
Nozzle (1)
.
4.06
SPOOL TORCH: Depress Torch Trigger Switch
MODEL: QLBF-200 III
MODEL: QLBF-185
MODEL: QLBF-24D and QLBF-36D
Torch Trigger Switch (9)
–
When depressed, the welding power is ener-
gized,
Welding Wire
(if fitted) is driven thru the Spool
Swan Neck
and
shielding gas flows (if gas is connected MIG/MAG equipment and turned
on) out of the
Swan Neck
.
DO NOT put Spool Torch near your ears or eyes when the
Torch Trigger (9)
is depressed as
Welding Wire
will rapidly
exit the Contact Tip then the Nozzle and will cause serious to
your ears, eyes, or skin.
Touching
Welding Wire
when electrically alive may cause fatal
shocks or severe burns.
Always wear Safety glass when operating or near MIG/MAG
equipment.
