Nortel SR1001, Руководство по установке, Страница: 78 / 82

66
APPENDIX B
Compliance and Standards FCC Conformance
SR1001 Installation Guide
Version 8.3.5
FCC Conformance
This section provides information about Nortel product conformance with FCC rules.
FCC Part 15
Nortel products comply with FCC Part 15 (also known as CFR42, Chapter 2, Part 15) of the
Federal Communications Commission (FCC) rules concerning radio frequency emissions for
Class A computing devices. The following section is required by the FCC.
CAUTION:
In accordance with FCC Part 15, Section 15.21, changes or modifications made by the buyer
that are not expressly approved by Nortel, could void the buyer’s authority to operate this equipment.
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is
likely to cause harmful interference, in which case the user will be required to correct the
interference at his own expense.
You can determine whether your equipment is causing interference by turning it off. If the
interference stops, it was probably caused by the Nortel equipment. If the equipment causes
interference to radio or television reception, try to correct the interference by using one or
more of the following measures:
„
Turn the television or radio antenna until the interference stops
„
Move the equipment to one side or the other of the television or radio
„
Move the equipment farther away from the television or radio
FCC Part 68
This equipment complies with Part 68 of the FCC rules. The FCC Part 68 label is located on the
bottom chassis panel. This label contains the FCC Registration Number and Ringer Equivalence
Number (REN) for this equipment. If requested, this information must be provided to your
telephone company.
Connection to the telephone network should be made by using standard modular telephone
jacks, type RJ-48C. The RJ-48C plug and/or jacks used must comply with the FCC Part 68
rules.
Incidence of Harm
If your telephone equipment causes harm to the telephone network, the telephone company
will notify you in advance that temporary discontinuance of service may be required. But if
advance notice is not practical, the telephone company will notify you as soon as possible.
Also, you will be advised of your right to file a complaint with the FCC if you believe it is
necessary.
MFRs Port
Identifier
Facilities
Interface
Code
Service
Order
Code
Network
Connectors
WAN Ports 1 04DU9-1SN
04DU9-1ZN 6.0N RJ-48C