Nortel Express Call Center, Руководство по установке

Страница: 33 / 48

Voice Services on Media Card Installation Guide 33
March 2005 Media Card
8 Log off the switch.
To enable or disable voice services ports
Use LD 32 overlay to enable and disable the Media Card. You also use LD 32
overlay to check the port status.
Note: Nortel recommends that the operator disable all Media Card digital units
in LD 32 before moving (MOV) or removing (OUT) them in LD 11. This is
because the Media Card does not receive any messages from the switch on a
move or an out command. This can lead to voice services ports being left in an
indeterminate state, as the Media Card receives no indication that the port has
been moved or outed.
Note: Perform this procedure only if the Media Card is not functioning properly
or if calls are not routed as intended. You may cause problems if you stop and
start the Media Card.
1 Log on to the switch.
2 Load Overlay 32 by typing LD 32 at the prompt.
3 Use the following commands to enable or disable Voice Services ports:
ATTENTION
Symposium Express Call Center supports a maximum of 24
ports on the Media Card. The actual number of usable ports
is determined by the keycode.
The number of ports enabled by the keycode appears on the
faceplate by K:
XX , where XX is the number of enabled ports.
Any remaining ports cannot be used for other purposes.
Command Description
ENLC l s c Enables the Media Card.
ENLU l s c u Enables a unit (voice services port).
DISC l s c Disables the Media Card.
DISU l s c u Disables a unit (voice services port).