Nortel Contivity 100, Настройка

Страница: 44 / 78

44 Chapter 2 Contivity 100 unit hardware installation
313369-A
2
Mount the unit on the wall.
Preparing a drywall or a cement wall for mounting
To prepare a drywall or cement wall for mounting, you will use a pencil to mark
where the brackets should be placed on the wall. Marking the wall makes
mounting easier because you limit the amount of time necessary to maneuver with
the weight of the unit in your hands and you ensure the accuracy of where the
holes are placed.
To prepare a drywall or a cement wall for mounting:
1
Place your unit with attached brackets against the wall where you want to
mount the unit.
2
Use a pencil to mark where the holes should be drilled in the wall for each
bracket.
3
Remove your unit from against the wall.
4 Use a drill and a 1/4-inch (0.63~0.65 mm) drill bit to drill four 1 1/16-inch
(27.0 mm) deep holes where you marked the wall for each bracket (eight
holes total).
5
Insert each of the plastic expansion lugs into the drilled holes.
After you prepare a drywall or a cement wall for mounting, you can mount the
unit on the wall (next).
Mounting the Contivity 100 unit on a drywall or cement wall
You will attach one bracket at a time to the wall.
To mount the Contivity 100 unit on a prepared drywall or cement wall:
1
Align the holes in the attached bracket with the expansion lugs in the wall.
Note:
Before you mount the unit on a wall, you must attach the brackets
to the unit. See “Attaching the brackets to the Contivity 100 unit” on
page 39 .