Starting the ARN
114200-E Rev 00
2-15
Entering
n
stops the Quick-Start script and returns you to the Technician
interface prompt. Entering
y
allows you to configure another module/port.
When the install script completes, the ARN starts bridging and routing traffic.
8.
Ensure that the ARN is successfully connected to your network.
To verify that the ARN is now connected to the network, contact your network
administrator. To troubleshoot any problems, your network administrator can
refer to
Configuring Passport Remote Access
.
If you need additional assistance, contact your local Nortel Networks
Technical Solutions Center.
Where to Go Next
Use the following table to determine where you want to go next.
Note:
After connecting the ARN to the network, you can replace the
management console connection with a modem connection to enable remote
dial-in access.
For information about
Go to
Operating the ARN
Chapter 3
Configuring the ARN for Netboot and
Directed Netboot
Appendix A
Using Local Boot (the Quick-Start Procedure)
Appendix B
ARN Technical Specifications
Appendix C
