9
Controller Mounting
Mounting the Controller in the Garage
The Garage Door Controller mounts in the garage near the garage door opener. It will need to be near
a power outlet and where its warning lamp can be seen, regardless of the door position.
Un-plug the
garage door opener before continuing.
The Garage Door Controller can be screw mounted directly, or by using the supplied adjustable
mounting bracket.
1.
Use the four anchors and screws to directly mount the Controller (use a 3/16” drill for the screw
anchors, if the anchors are used).
- OR -
1.
Snap the adjustable mounting bracket onto the Controller and secure it with the short screw.
2.
Use the bolts and nuts supplied to attach the mounting bracket to available hardware.
Figure 4. Controller Components
The GD00Z-8-ADT can also be attached to the opener's
hardware using the adjustable mounting bracket.
The optional adjustable
mounting bracket fits
3 ways on the controller.
The bracket snaps onto
indents on either side or
on the end of the controller.
SECURE BRACKET
WITH SCREW
INDENT
INDENT
Use the bolts and nuts
supplied to attach the
bracket to a secure
structure.
Be sure the controller is clear
of all of the garage door’s
moving parts, and the warning
lamp is not obstructed.
INDENT
1A
2A
3/16" HOLES
FOR ANCHORS
Use the four screws
and anchors to mount
the GD00Z-8-ADT above
the opener.
1
TYPICAL MOUNTING METHOD
ALTERNATE MOUNTING METHOD
The GD00Z-8-ADT typically
mounts on the ceiling near
the opener and the power
outlet.
TILT SENSOR
MOUNTED ON
THE TOP PANEL
OF THE DOOR
THE GD00Z-8-ADT WARNING
LAMP MUST BE VISIBLE IN
ALL DOOR POSITIONS
REMOVE POWER FROM THE
GARAGE DOOR OPENER
BEFORE CONTINUING
! WARNING !
Figure 5. Controller Mounting
