GC2e Wireless Security System | Installation and Programming Guide
©2020 Nortek Security & Control LLC. All rights reserved.
6
2GIG is a registered trademark of Nortek Security & Control LLC.
Introduction
Optional Accessories
Optional modules, keypads, radios, and sensors that can be purchased to enhance the system include:
• 2GIG LTE (Cellular) Radio Module. An on-board digital communicator reports alarms and trouble to a Central
Station receiver and a two (2)-way voice communication with the Central Station. It also supports OTA updates
and remote control of the system using a Web-enabled device through the Internet.
• 2GIG 900 MHz Transceiver Module . It sends and receives signals with wireless touch screen keypads and image
sensors . Touch screen keypads allow remote control of the system through the same graphic interface design as
the 2GIG Control Panel. Note that the 2GIG 900 MHz Transceiver Module, touch screen keypad, and image sensor
are only available in some regions .
• 2GIG Wireless Touch Screen Keypad. A wall-mounted, full-color, touch screen interface that provides many of
the same easy-to-use keypad functions available on the Control Panel. It is designed for indoor use only and gives
users the ability to control lights, thermostats, and door locks, as well as to view the status of every sensor zone .
When the 2GIG 900 MHz Transceiver Module is installed in the Control Panel, the system can be programmed to
communicate with up to four (4) Wireless Touch Screen Keypads .
• 2GIG Go!Bridge IP Communicator. The Go!Bridge provides Internet connectivity between the monitoring
service’s Central Station and the Go!Control® Panel (requires the 2GIG 900 MHz Transceiver Module and supports
automatic firmware updates, provides interactive security services, and increases supervision using signal-
forwarding to the Central Station.
• 2GIG Super Switch Takeover Module . The takeover module communicates with the 2GIG Control Panel and is
designed to convert up to eight (8) pre-wired zones to supervised wireless zones.
• 2GIG Hardwire Conversion Kit. This kit provides installers with an easy way to convert the zones of a pre-wired
security alarm system to 2GIG wireless zones . The kit includes one (1) Super Switch Takeover Module (Wireless
Takeover of an Alarm System, US Patent No. 8,638,218). You can also install two (2) additional modules, which
provides installers with the capability to convert up to 24 pre-wired security zones to wireless zones.
2GIG GC2e Security Panel XCVR Compatibility
The GC2e panel with the factory-installed XCVR2a is compatible with the new eSeries encrypted sensors and legacy
non-encrypted 345 sensors. This receiver is not compatible with the TS1 or Image Sensor 1 or 3 accessories.
The TS1 and Image Sensor 1 can be used with the GC2e by replacing the XCVR2a with a 2GIG-XCVR2e-345, which is
compatible with the TS1 keypad, the Image Sensor 1 and eSeries sensors and legacy security sensors.
The Image Sensor 3 can be used with the GC2e by replacing the XCVR2a with a 2GIG-XCVR5e-345, which is compatible
with Image Sensor 3, eSeries sensors and legacy security sensors. (2GIG-XCVR5e-345 is not compatible with TS1
keypads .)
Содержание 2GIG eSeries GC2e
Страница 2: ......
