20
21
Maintenance (once a month)
If the water filter is covered with debris, the hot water will not run smoothly, or cold water may
come out. Clean the filter as explained below.
* To avoid burns, wait until the equipment cools down before draining the water. The
appliance remains hot after it is turned off.
Water filter
1. Close the water supply valve.
2. Open all hot water fixtures.
3. Loosen the Drainage Outlet.
4. Remove the Drainage Outlet from the band.
(see illustration on right).
* Water will drain out.
5. Clean the filter with a brush under running
water.
6. Replace and screw the Drainage Outlet
closed.(Take care not to lose the packing.)
7. Close all hot water fixtures.
8. Open the water supply valve and check that
water is not leaking from the Drainage Outlet.
Water supply valve
Temperature
Hot water is not available when
the hot water fixture is opened.
•
Are the gas and water supply valves fully open?
•
Is the water supply cut off?
•
Is the hot water fixture sufficiently open?
•
Is the heater frozen?
•
Is the gas meter working?
•
(For LP) Is there enough gas in the tank?
•
Is the operation button turned on?
•
Have you allowed enough time for the cold water in the
pipes to drain out?
•
Are the gas and water supply valves fully open?
•
Is the water temperature setting appropriate (
p.12
and p.13)?
•
If the supply water is at a high temperature, you may
need to increase the flow rate through the heater to get
a low temperature out of it.
Hot water is not available at low
temperatures.
Cold water comes out when the
fixture is barely opened. Only
cold water is available at low
flow rates.
•
The heater stops burning when the flow of hot water
becomes less than 0.75 GPM. Open the hot water
fixture more, and the water temperature will stabilize.
Troubleshooting-1
•
Are the gas and water supply valves fully open?
•
Is the water temperature setting appropriate (
p.12
and p.13)?
Hot water is not available at
high temperatures.
Band
Packing
Drainage Outlet
Water filter
Содержание N-063
Страница 30: ...58...