Rhino
R
VE Bulk Unloaders, 125-mm Frame
26
Part 1608271-04
E
2019 Nordson Corporation
CAUTION:
To prevent damage to the follower plate seals, do not use
petroleum-based products. Use O-ring grease.
8. Coat the follower plate seals (6) with O-ring grease.
9. Place the container of material between the drum centering shoes (5)
and center it under the follower plate (7).
10. Remove the bleeder stem (9) from the bleeder stem/blow-off port (8) to
relieve any air trapped under the follower plate (7).
WARNING:
Wear protective colthing, gloves, and safety glasses when
lowering the follower plate into the container. The expelled air from under
the follower plate may contain material.
11. Press and hold in the
Ram Down
push buttons at the same time to
manually lower the follower into the pail. When the follower enables the
Follower in Pail
switch, release the
Ram Down
push buttons.
12. Perform the following:
a. When material starts to continuously flow from the bleeder
stem/blow-off port (8), press and release the
Ram Up
push button to
stop ram movement.
b. Install the bleeder stem (9) into the bleeder stem/blow-off port and
tighten securely. Use a rag to remove excess material around the
bleeder stem/blow-off port.
13. Press and hold in the
Ram Up
push buttons at the same time to start
automatic ram movement.
14. Open the air motor ball valve (1).