Instruction Sheet
P/N 1029724A
Hose/Gun Module Service Kit - P/N 1028328
Use this service kit to replace a hose/gun module in all ProBlue melters.
WARNING: Risk of personal injury or equipment damage! Refer to
the safety information provided in the melter manual before servicing
the melter. Failure to comply with the safety information provided
can result in personal injury, including death.
Tools:
Philips-head screw driver
Hose/Gun Module
3.
Disconnect the hose cordsets from the back of the failed module and then re-
move module from the melter.
WARNING: Risk of electrocution! The control switch does
not remove high-voltage power from the melter. Before open-
ing the electrical compartment door, ensure that the local pow-
er disconnect switch is in the off position and locked. Failure to
properly disconnect power from the melter can result in per-
sonal injury, including death.
2.
Switch the melter off.
1.
Disconnect power to the melter at the local power disconnect switch.
6.
Connect the hose cordsets to the back of the new module.
Note:
The modules are interlocked with one another. To remove
the bottom-most module, you must first remove the modules above it.
7.
Restore power to the melter and then switch the melter on. Verify that the
melter starts normally and that the melter recognizes the hoses/guns that are
connected to the new module.
4.
Ground yourself by momentarily touching the chassis of the melter.
5.
Install the new module and replace any other modules that were removed.
Tighten the module fastening screw.
CAUTION: Before removing the hose/gun module from its
anti-static bag, ground yourself by touching the chassis of the
melter or another grounded structure. Failure to properly
ground yourself can cause electrostatic discharge resulting in
damage to the hose/gun module.
