NPE-LF10 and NPE-HF10 Powder Spray Guns
4
Part 108191C
E
2003 Nordson Corporation
Safety Label
Table 1 contains the text of the safety label on this equipment. The safety
label is provided to help you operate and maintain your equipment safely.
Table 1 Safety Label
Part
Description
244644
WARNING:
The following procedures MUST be followed when working with
this electrostatic spray equipment. Failure to follow these instructions may
result in a fire and/or serious personal injury. Display this warning on the spray
booth.
1. NO SMOKING. Keep open flames, hot surfaces, and sparks from torches or
grinding away from booth.
2. Turn the electrostatic power unit off when the spray gun is not in use.
3. Shut down immediately in event of fire.
4. Maintain ground circuit on all conductive objects below 1 megohm to prevent
sparking. (ANSI/NFPA 33, Chapter 9, or local codes).
5. Shut down operation and correct grounds if sparking occurs.
6. Install fixed fire suppression system in accordance with ANSI/NFPA 33,
Chapter 7 (or local codes), before operating with combustible powder.
7. Install automatic flame detectors in accordance with ANSI/NFPA 33,
Chapter 7 (or local codes), before operating automatic guns
8. Examine all equipment at the beginning of each work period and repair or
replace any damaged, loose, or missing parts.
9. Before cleaning or performing any maintenance on the electrostatic spray
gun, turn off the power unit and ground the nozzle. Maintain electrostatic
spray equipment in accordance with instruction manual. Do not deviate. Do
not substitute parts from other manufacturers.
10. Operator must be grounded to prevent shocks from static electricity. Floor
surface must be conductive. Footwear and gloves must be static dissipative
in accordance with ANSI Z41-1991 (or local codes).
11. Air velocity through all booth openings must meet local requirements and
contain powder within the booth. If powder escapes from the booth, shut
down operation and correct the malfunction.
12. Powder may be toxic or be a nuisance dust hazard. Refer to supplier’s
MSDS. If exposed to dust during operation, maintenance, or clean up,
operators must use appropriate personal protective equipment.
13. Do not use compressed air or organic solvents for removal of powder from
skin or clothing. Do use soap and water. Wash hands before eating or
smoking.
14. Guns, feeders, booths, etc., may be cleaned with clean dry air at 1.7 bar
(25 psig).
If you have any questions concerning this electrostatic spray equipment, call
(440) 988-9411, and ask to speak with the Powder Systems Group Technical
Service Department.
