NPE-LF10 and NPE-HF10 Powder Spray Guns
6
Part 108191C
E
2003 Nordson Corporation
Specifications
Table 2 Dimensions
Dimensions
mm (in.)
ÁÁÁÁÁÁÁÁÁÁÁÁ
ÁÁÁÁÁÁÁÁÁÁÁÁ
Height
ÁÁÁÁÁÁÁÁÁÁÁÁ
ÁÁÁÁÁÁÁÁÁÁÁÁ
80 (3.125)
ÁÁÁÁÁÁÁÁÁÁÁÁ
ÁÁÁÁÁÁÁÁÁÁÁÁ
Length (overall)
ÁÁÁÁÁÁÁÁÁÁÁÁ
ÁÁÁÁÁÁÁÁÁÁÁÁ
389 (15.3)
ÁÁÁÁÁÁÁÁÁÁÁÁ
ÁÁÁÁÁÁÁÁÁÁÁÁ
Length (mounting hole forward)
ÁÁÁÁÁÁÁÁÁÁÁÁ
ÁÁÁÁÁÁÁÁÁÁÁÁ
306.4 (12)
ÁÁÁÁÁÁÁÁÁÁÁÁ
ÁÁÁÁÁÁÁÁÁÁÁÁ
Mounting hole diameter
ÁÁÁÁÁÁÁÁÁÁÁÁ
ÁÁÁÁÁÁÁÁÁÁÁÁ
13 (0.5)
ÁÁÁÁÁÁÁÁÁÁÁÁ
ÁÁÁÁÁÁÁÁÁÁÁÁ
ÁÁÁÁÁÁÁÁÁÁÁÁ
ÁÁÁÁÁÁÁÁÁÁÁÁ
Powder feed hose ID:
NPE-LF10
NPE-HF10
ÁÁÁÁÁÁÁÁÁÁÁÁ
ÁÁÁÁÁÁÁÁÁÁÁÁ
ÁÁÁÁÁÁÁÁÁÁÁÁ
ÁÁÁÁÁÁÁÁÁÁÁÁ
13 (0.5)
19 (0.75)
Air Supply
Powder spray systems require clean, dry, oil-free operating air. Moist or
oil-contaminated air can cause the powder to clog in the pump venturi
throat, feed hose, or gun passages.
Use 3-micron filter/separators with automatic drains and a refrigerated or
regenerative desiccant-type air dryer that can produce a 3.4
_
C (38
_
F) or
lower dewpoint at 6.89 bar (100 psi).
Installation
WARNING:
Allow only qualified personnel to perform the following tasks.
Follow the safety instructions in this document and all other related
documentation.
WARNING:
Ground all electrically conductive equipment in the spray area.
Ungrounded or poorly grounded equipment can store an electrostatic
charge that can give personnel a severe shock or arc and cause a fire or
explosion.
See Figure 2.
Gun Mounting
Unpack the spray gun and install it on a gun mounting bar (6), gun stand, or
reciprocator arm. The clamp on the gun mounting bar shown in Figure 2 is
used with square or round bars (1) up to 25-mm (1-in.) in diameter.
The hole in the gun mounting block (7) is 13-mm (
1
/
2
-in.) in diameter.
Tighten the square head screw in the mounting block to hold the spray gun
in a fixed position.
