© 2021 Nordson Corporation
8-14
Feed Hopper Fluidizing Plate Replacement
75-lb Feed Hopper Fluidizing Plate Replacement
1. Empty the hopper and vacuum as much powder as possible out of the hopper.
2. See Figure 8-12
. Remove the screws (5), flat washers (6), and nuts (7) securing the
body (1) to the plenum (4). Lift the body off the plenum.
3.
Remove and discard the old fluidizing plate (2) and U-gasket (3).
4.
Vacuum the inside of the plenum and clean the body and plenum flanges.
5.
Install the U-gasket around the outside edge of the new fluidizing plate.
NOTE:
Make sure that the smooth side of the new fluidizing plate is facing up.
6.
Re-assemble the body, fluidizing plate, and plenum with the screws, washers, and
nuts.
CAUTION:
Do not overtighten the nylon screws. Overtightening the screws will result in
stripped threads and possible air or powder leaks.
Содержание Encore XL Powder
