Operation
4-2
Part 7135457- E
E
2017 Nordson Corporation
Color Change Procedure
1. Leave the guns spraying until products pass the spray guns.
Figure 4-1
ColorMax
3
in
operation
2. Wait until the products are outside of the booth.
3. Turn the spray guns off on the application control panel. Refer to
Gun
control
manuals.
Figure 4-2
Preparation for
color change
4. Put
Powder Feed Centre
into clean mode. Refer to
Powder Feed Centre
manuals.
5. Withdraw the guns so that just the nozzles are left inside the booth.
6. Close the booth doors.
7. Start the gun purge process. Refer to
Powder Feed Centre
manuals.
8. Blow off the exterior of the
dip legs
and
fluid assist
. Refer to
Powder
Feed Centre
manuals.
9. Start the pump purge sequence. Refer to
Powder Feed Centre
manuals.
Figure 4-3
Spray guns in purge
position
