Nordmann es4 4, Инструкция по установке и эксплуатации

Страница: 20 / 68

20
The installation site of the steam humidifier depends largely on the location
of the steam distributor (see chapter 4.4). To ensure proper functioning
of the steam humidifier and to obtain an optimal efficiency , the following
points must be considered and observed when choosing the location for
the steam humidifier:
– Install the steam humidifier so that the
length of the steam hose is kept
as short as possible ( max. 4 m ) and that the minimum bend radius
(R= 300 mm) and up-slope (20 %) or down-slope (5 %) of the steam
hose is observed (see chapter 4.4.5).
– The steam humidifiers Nordmann ES4 4 are designed for wall­mount-
ing. Make sure that the construction (wall, pillar, floor­mounted console,
etc.) to which the humidifiers are to be mounted, offers a sufficiently
high load-bearing capacity (take notice of the weight information
found in the dimensions and weights table above), and is suitable for
the installation.
CAUTION!
do not mount the steam humidifier directly to the ventilation duct
(insufficient stability).
– The back panel of the Nordmann ES4 4 is retaining heat during opera-
tion (max. surface temperature of the metal housing approx. 60 ­ 70 °C).
Make sure, therefore, that the construction (wall, pillar, etc.) to which the
units are to be mounted, does not consist of heat­sensitive material.
– Install the steam humidifier in such a manner that it is freely accessible
with sufficient space available for maintenance purposes (refer to the
above illustration for minimum distances).
– the nordmann es4 4 is protected according to IP20 . Make sure the
units are installed in a drip­proof location and the admissible ambient
conditions are complied with.
– The steam humidifier Nordmann ES4 4 may only be installed in rooms
with a floor drain.
CAUTION!
If for some reason the Nordmann ES4 4 must be installed in a location
without floor drain, it is mandatory to provide a leakage monitoring
device to safely interrupt the water supply in case of leakage.
– When fixing the Nordmann ES4 4 use only the fixing materials sup -
plied with the unit . If fixing with the materials supplied is not possible in
your particular case, select a method of fixing that is of similar stability.
– The Nordmann ES4 4 is designed for installation and operation inside
buildings.