NordicTrack SpaceSaver SE5i, Руководство пользователя

Страница: 18 / 28

18
MAINTENANCE
Regular maintenance is important for optimal
performance and to reduce wear. Inspect and properly
tighten all parts each time the elliptical is used.
Replace any worn parts immediately.
To clean the elliptical, use a damp cloth and a small
amount of mild soap. IMPORTANT: To avoid damage
to the console, keep liquids away from the console
and keep the console out of direct sunlight.
CONSOLE TROUBLESHOOTING
The console requires activation. If you have not acti-
vated the console, see assembly step 7 on page 8.
If the console does not display your heart rate when
you hold the handgrip heart rate monitor, or if the dis-
played heart rate appears to be too high or too low, see
step 5 on page 13.
If a replacement power adapter is needed, call the
telephone number on the cover of this manual.
IMPORTANT: To avoid damaging the console, use
only a manufacturer-supplied regulated power
adapter.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted. To adjust the reed
switch, first unplug the power adapter.
Remove the
four M4 x 16mm
Screws (not
shown) from the
Large Storage
Foot (27), and
then remove the
Large Storage
Foot. Next,
remove the two
M4 x 16mm
Screws (not
shown) from the Top Shield (37), and then use a stan-
dard screwdriver to pry the Top Shield upward off the
elliptical.
Look into the access opening and locate the Reed
Switch (58). Rotate the Pulley (66) until a Magnet (41)
is aligned with the Reed Switch. Note: For clarity, the
shields are shown removed in the drawing below.
Next, slightly loosen the two indicated M4 x 16mm
Screws (61). Slide the Reed Switch (58) slightly
toward or away from the Magnet (41). Then, retighten
the Screws.
Plug in the power adapter and rotate the pulley for a
moment. Repeat these actions until the console dis-
plays correct feedback.
When the reed switch is correctly adjusted, unplug
the power adapter and reattach the parts that you
removed.
37
27
MAINTENANCE AND TROUBLESHOOTING
58
41
61
66