NordicTrack NEL90950, Руководство пользователя

Страница: 7 / 28

7
95
15
11
121
88
14
13
12
7. Identify the Left Pedal (14). Attach the Left Pedal to the
Left Pedal Arm (12) with three M8 x 23mm Flat Head
Screws (88), three M8 Washers (94), and three M8
Nylon Locknuts (102). Then, press the Left Pedal
Insert (121) onto the Left Pedal.
Attach the Right Pedal (13) to the Right Pedal Arm (not
shown), and press the Right Pedal Insert (122) into the
Right Pedal, in the same way.
6
7
6. Apply a small amount of grease to the axle on each
Pivot Shaft (15). Next, hold a Pedal Wheel (35) inside
of the end of the Right Pedal Arm (11). Then, insert a
Pivot Shaft through the holes in the end of the Right
Pedal Arm and the Pedal Wheel as indicated.
Tighten an M8 Nylon Locknut (102) with an M8 x
25mm Washer (95) onto the end of the Pivot Shaft
(15).
Attach the other Pivot Shaft (15) and the other Pedal
Wheel (35) to the Left Pedal Arm (12) in the same way.
5. See the inset drawing. While another person tips the
elliptical exerciser as shown, place a sturdy piece of
packaging foam beneath the elliptical exerciser.
Orient the Rear Stabilizer (2) so that the holes are
toward the front. While another person steadies the
elliptical exerciser, attach the Rear Stabilizer to the
back of the Frame (1) with four M8 x 68mm Button
Screws (110) and four M8 Split Washers (101).
Carefully remove the piece of packaging foam and tip
the elliptical exerciser back down.
5
1
110
110
101
2
35
35
102
12
15
88
102
94
Grease
122