nord B 1050, Инструкция по эксплуатации и сборке

Страница: 78 / 112

Industrial gear units – Operating and Assembly Instructions
78 B 1050 en-4419
5.2.14 Taconite seal
Input and/or output shafts may be equipped with Taconite seals, depending on the version. The
associated grease nipples are located either directly on the bearing cover or re-lubrication must be
carried out via a lubrication line.
Legend
1: Bearing cover 1
2: Grease-filled gap
3: Conical grease nipple
4: Bearing cover 2
Figure 31: Re-greasing Taconite seals
The precise position of the grease nipples can be obtained from the specific dimension sheet for the
order. The seal must be filled with grease until clean grease emerges from the grease gap. Remove
excess grease.
Recommended grease: Petamo GHY 133N - Klüber Lubrication (please see chapter 7.3.1 "Roller
bearing greases")
Information
Optimal re-lubrication is achieved by rotating the gear unit shaft in 45° steps when lubricating and
pressing in grease until clean grease emerges from the shaft.