nord B 1050, Инструкция по эксплуатации и сборке, Страница: 37 / 112

3 Assembly instructions, storage, preparation, installation
B 1050 en-4419 37
Installation and assembly
WARNING
Hazards from rotating parts
There are moving parts (e.g. shafts) on the individual components of the drive package. These can
rotate quickly and lead to injuries (e.g. crushing, strangling, etc.).
• Do not operate the drive without covers or hoods.
• Secure the drive against inadvertent switching on during installation work.
• Pay attention to the additional information contained in the operating and assembly instructions for
third-party components.
• Pay attention to the job-specific information on brake and coupling components contained in the
dimension sheet or the order confirmation.
NOTICE!
Risk of gear unit damage from faulty installation
Impermissible tension, distortion and poor stability can damage the gear unit and attached
components.
• Use the right lashing points.
• Install the drive package on a horizontal and level surface.
• Ensure that foundation and torque arm are dimensioned adequately.
• Do not exceed the maximum permissible distortion of 0.1 mm at a distance of 1 m.
• Check and correct the alignment of mounted components (Pay attention to the manufacturers’
documentation).
• Ensure a non-distorted alignment to the shaft of the connected machine.
Impermissible distortion and poor stability of the gear unit significantly affect the wear pattern of gear
wheels, the load on the bearings, and consequently the service life of the gear unit.
Components between the motor and the gear unit, e.g. turbo couplings or brakes are pre-adjusted
prior to delivery: The alignment and adjustment of these components must be checked and corrected
according to the corresponding manufacturer's documentation prior to commissioning the gear unit.
Incorrect alignment will result in premature failure of the attached components and the gear unit.
Pay attention to all the notes on installation and assembly contained in the present manual and also
the separate operating and assembly instructions of all installed components (e.g. couplings or
brakes).
Additional notes on the installation of the motor base frame
• Solid shaft with elastic output coupling, see section 3.6 "Fitting hubs on the gear shafts"