Owner’s Manual 8
A good time to clean the refrigerator is just after you defrost it.
Clean the inside of the refrigerator as often as necessary to avoid
food odors:
- Remove all food from the refrigerator.
NOTE: Do not use abrasive cleaners, chemicals, or
scouring pads because they can damage the
interior of the refrigerator.
- Wash the interior with a solution of liquid dish detergent and
warm water.
- Rinse with a solution of baking soda and clean water.
- Dry with a clean cloth.
- Put all food in the refrigerator.
Drip tray:
To remove and clean the drip tray:
- Locate the plastic clip that is around the wire shelf in front of
the drip tray.
- Remove and save the screw that attaches the plastic clip to
the inside of the refrigerator cabinet.
- Pull the self forward to remove from the refrigerator
- Make sure that the drip tray is empty of water.
- Pull the drain tube plug out from the inside of the drip tray
and out of the drain hose.
- Pull the drip tray forward to remove from the slots in the
refrigerator cabinet.
- Clean the drip tray.
- Put the drain tube plug down into the drip tray and push the
drip tray back into the original position.
- Push the drain hose back onto the drain tube plug.
- Put the wire shelf and plastic clip back in the original position.
- Attach the plastic clip with the screw.
Cleaning
- Start up the refrigerator.
- Allow the refrigerator to cool down.
- Return all food to the refrigerator.
Refrigerator Maintenance Checklist
Read and understand the following maintenance sections of this
manual.
NOTE: Norcold is not responsible for installation,
adjustment, alteration, service, or maintenance
performed by anyone other than a qualified RV
dealer or an authorized Norcold Service center.
Have a qualified RV dealer or an authorized Norcold Service
Center do these annual safety and maintenance checks:
- Examine the gas supply lines for leaks.
- Replace or repair if necessary.
- Make sure the propane gas pressure is 11 inches of water
column.
- Adjust if necessary.
- Make sure the combustion seal is complete and intact.
- Replace or repair it if necessary.
Door Sealing
If the door does not seal correctly, excess frost will collect inside
the refrigerator. Make sure the door seals correctly:
- Close the door on a piece of paper that is about the size and
thickness of a dollar bill (See Art00980).
- Gently pull the paper.
- You should feel a slight drag between the gasket and the
cabinet.
- Do this on all four sides of the door.
- If you do not feel a slight drag on the
paper, the door is not sealing correctly:
- Make sure the screws of the hinges are tight.
- Make sure the door gasket does not touch the door
latch:
- If the door gasket touches the door latch,
loosen the screws of the door latch.
- Raise the door latch just so it does not touch
and tighten the screws of the door latch.
- Make sure the door latch holds the door closed
