Norcold N260, Руководство по обслуживанию

Страница: 11 / 14

Service Manual N260 Series - 11
Part Replacement
If the “Troubleshooting Charts” tell you to replace a part, use
the following instructions.
Selector switch
1. Close the valve of the LP gas tank(s).
2. Remove the control panel from the back of the refrigerator.
3. Remove the burner tube from the burner assembly.
4. Pull the knob off the selector switch.
5. Remove the two screws that attach the selector switch.
6. Gently pull the selector switch away from the back of the
control panel.
7. Remove each wire, one at a time, from the selector switch
and install in exactly the same location on the replacement
selector switch. (See Art01022 and Art01023)
8. To install the replacement selector switch, do steps 1-7 in
reverse.
Thermostat
1. Close the valve of the LP gas tank(s).
2. Remove the control panel from the back of the refrigerator.
3. Pull the knob off the thermostat.
4. Remove the gas supply line from the inlet flare fitting of the
themostat.
5. Remove the burner tube from the burner assembly.
6. Remove thermocouple then safety valve from thermostat.
7. Remove the two screws that attach the thermostat to the
bracket.
8. Remove the two red wires from the thermostat.
9. Remove the clips that attach the capillary tube tube to the
cooling fin inside the refrigerator.
NOTE: The capilllary tube is located on the fifth cooling fin
from the right.
10. Gently pull the capillary tube through the back of the
refrigerator cabinet.
11. To install the replacement thermostat, do steps 1-10 in
reverse.
12. Examine all the LP gas connections for leaks.
AC heater
1. Remove the AC power cord from the receptacle.
2. Remove the two black wires that connect the AC heater to
the terminal block.
3. Using a utility knife, vertically cut through the insulation
that surrounds the flue tube.
4. Remove the insulation.
5. Pull the AC heater up and out of the heater well.
6. Push the replacement AC heater down into the heater well.
- Make sure the bead of weld on the AC heater touches the
top of the heater well.
7. Put the insulation around the flue tube.
- Make sure the insulation is completely around the flue
tube.
8. Tape the insulation closed.
9. Attach the two black wires of the AC heater to the terminal
block.
10. Put the AC power cord in the receptacle.
DC heater (3-way models)
1. Remove the DC input leads from the refrigerator.
- Put tape on the positive lead to prevent an accidental
electrical short and a blown fuse.
2. To make sure the other energy sources do not activate,
turn the selector switch to DC.
3. Remove the two yellow wires that connect the DC heater
to the terminal block.
4. Using a utility knife, vertically cut through the insulation
that surrounds the flue tube.
5. Remove the insulation.
6. Pull the DC heater up and out of the heater well.
7. Push the replacement DC heater down into the heater
well.
- Make sure the bead of weld on the DC heater touches
the top of the heater well.
8. Put the insulation around the flue tube.
- Make sure the insulation is completely around the flue
tube.
9. Tape the insulation closed.
10. Attach the two yellow wires of the DC heater to the
terminal block.
11. Make sure that a 20 Amp fuse is in the fuse holder.
12. Attach the DC input leads from the refrigerator.